PREMANT district heating pipe
Table of Contents
6.318
Parallel T-piece; heating, insulation thickness 3
6.320
Fixed point; thermally and electrically separated, insulation thickness 2
6.321
Reduction piece
6.322
Vent
6.323
Drainer
6.325
Fittings installed in the ground; description, installation and operating instructions
6.330
Ball valve
6.332
Ball valve with 2 vents
6.333
Ball valve with 1 vent
6.334
Ball valve for installation in the ground, installation diagram
6.335
Accessories: shut-off fitting, ball valve
6.340
Joint; shrink sleeves
6.342
Joint, shrink-on reduction sleeve/end sleeve
6.345
Brugg VISUCON
6.350
EWELCON electro-welding joint, system description
6.351
EWELCON electro-welding joint, technical data
6.352
EWELCON-S electro-welding joint
6.353
EWELCON-S electro-welding joint
6.354
Fitting bend
6.355
Wall sealing ring, pipe warning tape
6.356
Shrink-on closure
6.357
Rigid foam beam
6.360
Ring seal
6.365
Expansion pad
6.400
Transport and storage
6.403
Storage of preformed parts
6.410
Assembly foam
6.500
Underground construction, installation
6.500
Underground construction work, installation
6.501
Underground construction work, installation
6.502
Filling in the pipe trenches
6.505
House lead-in, wall seal – neoprene rubber
6.510
Installation instructions
6.515
Concrete block for fixed point, for maximum fixed point forces
6.520
Sectional drainage, sectional venting
6.525
Underground construction work for ball valve, shafts with drive-over cast cover
6.530
Tapping technology, system description
6.531
Tapping technology, dimensions and measurements
6.532
Tapping technology, weld seam preparation and structure
6.533
Tapping technology, junction branch at top with 45° PRE bend
6.534
Tapping technology, junction branch at top with 45° welded bend
6.535
Tapping technology, junction branch at bottom with 45° PRE bend
6.536
Tapping technology, junction branch at bottom with 45° welded bend
6.537
Tapping technology, junction branch at top with 90° PRE bend
PRE 6.0
23.5.2023 BGP
Subject to technical changes
